B-7A-3 | Cabinet, Bacteriological Laboratory

Intended Use: Medical/Dental Dept. of Larger Ships

Download PDF

SFC No. B-7A-3
Hull Type Drawing No. No. 805-1641530, 805-1641531
NSN: None

Principal Material: Aluminum, Stainless Steel
Remarks: COLUMNS A,B,C,D, AND E REFERENCE UNIT ASSEMBLY SCHEDULE.

• Unit 3494, shown, consists of cabinets: A, B, C, and D. (E is identical to D differing only in width, see table of dimensions above). A description of the cabinets starting from the top down to the counter then from right to left is as follows:
  • Cabinets D and E: Sliding doors provide access to shelf trays adjustable in 1-inch increments.
  • Shelves: Quantity is, “as required”. Specify number per cabinet when ordering.
  • Drying Rack: Perforated CRES panel with ten plastic pegs.
  • Counter Backsplash: CRES panel contain:
    • Power supply – two 110V ac Duplex outlets, one at each end. Unit No. 3488 has only one.
    • Hot and cold water supply – specify fixture.
    • One gas turncock.
    • CRES counter contains integral CRES sink, 12″ square.
• Cabinet A: The right cabinet compartment must be modified so as to be identical to the left hand compartment as per Section E-E of of HTD No. 805-1641531 (this compartment; originally designated for stowage of propane tank is not an approved location for flammable material).
• Center door provides access to piping, a single fixed shelf 12″ deep is located under the sink trap.
• Left hand compartment contains two adjustable shelves.
• Cabinet B: Knee-hole unit has a single drawer with latch. Drawer measures 17″ W, 22″ D, 4″ H.
• Cabinet C: Lower compartment is 24″ high and contains two fixed shelves. Drawer with latch measures 17″ W, 22″ D , 4″ H.